how to setup plot area in autocad for mac

Setup Plot Area In Autocad Software Is Installed

WHAT IS THE PROCEDURE Reply Adelina Slavkova says: February 17, 2011 at 3:48 pm Thanks A Lot The steps work great.

This requires few setup configurations to the PostScript plotter on your computer.

To create EPS files, all you need to do is to add a virtual plotter that uses the EPS format and then configure it to plot to a file rather than to a physical plotter.

Setup Plot Area In Autocad Software Is Installed

AutoCAD does not automatically create the PostScript plotter for you when the software is installed by default, it require minor configuration, a simple wizard that will guide you thru steps by steps.

Create Adobe EPS Virtual Plotter To add a EPS plotter to AutoCAD you have to use the Add Plotter wizard.

After clicking on it, a dialog box will appear, which tells you a little about the wizard.

This window will asks you to determine the type of plotter you want to add.

If you are not sure how the files will be used, select Level 1.

The main difference would be the file size produce using Level 2 which is smaller and the support for Adobe Photoshop version 6 and above, where else Level 1 is for version 6 and below.

The next dialog box to appear would be the Import Pcp or Pc2.

Ignore this dialog due to the fact that it is the configuration for a physical printer.Proceed by clicking the next button.

Next would be the naming of the file, you can leave it default or key in the preference name.

The Finish page gives you the option of editing the plotter configuration or calibrating the plotter.

Checking The Plotter Finally, your EPS plotter should be ready for use, double check that the file is created by selecting the tab File then go to Plot, from the pull down list of printer selecet the EPS plot file.

With all the setting properly config, you are now able to plot to scale.

Popular Article Autodesk AutoCAD Architecture Desktop Napkin Freehand Sketch Common Mistake When Importing EPS to Photoshop One of the most common mistake when it comes to importing the Adobe EPS file into Adobe Photoshop is mismatch of resolution, for instant the A1 photoshop file you are working on is in a resolution of 100 dpi, and when you import the EPS, the resolution to render should be 100 dpi too.

If the resolution when importing is 50dpi, the size will be half when copies and pasted onto the A1 board.

Make sure the resolution is the same when importing the EPS file.

Recap: If the A3 presentation is in 300 dpi, remember to import the EPS file with the same A3 dimension and dpi Recommended for you: Gradient Masks over AutoCAD with Photoshop Adobe Photoshop Image Masking Online Tutorial AutoSave For Adobe Photoshop CS4, CS5, and CS6 Tutorial Disable AutoDesk AutoCAD Animated Zoom Ngan Tengyuen Latest posts The author is not a CAD expert nor a web genius.

The tutorials featured here are meant for basic level understanding.

Download 7 Layered Architectural Backdrops 25 Fictional Architects In Movies 6 Cities and their Skyscrapers Reaching for the Stars 25 Funny Doodles on Coffee, Sleeping, Working Life and etc View all 8 Comments Ben Jurin says: March 15, 2008 at 3:51 am A much simpler alternative is to plot your cad drawing to pdf then open it in ps.

Providing you plot to the correct scale and dont alter the size of it in ps then when you print it will be to scale.

Reply art says: November 2, 2008 at 11:30 pm I CANNOT PLOT MY AUTOCAD DRAWING IN HP DESKJET 1280.

How To Setup Plot Area In Autocad For Mac